OUR SERVİCES

In-hole Honing

Honing is applied on in-hole surfaces to achieve
surface and measurement precision after turning
WHAT WE DO

In-hole Honing Capacity

Diameter Length Number
200mm 400mm 1
300mm 1200mm 1
300mm 2000mm 1
350mm 2000mm 1
550mm 3500mm 1

Honing is applied on in-hole surfaces to achieve surface and measurement precision after turning. This process is carried out by the chip removal process as a result of the movement of abrasive granular stones attached to the heads of honing machines back and forth with the help of a certain pressure on the hole surfaces of stones.

With this technique, chips up to 0.3mm can be removed from the surface.

Surface roughness can be achieved up to Ra0.02 μm with suitable granular stones and special sanding technique.

The lines formed on the surface after honing process between 20-45 degrees also help for keeping oil on the hydraulic pipe surface.

0.3 mm of chips can be removed from the surface by the technique of perforation.

WE ARE WITH YOU ALL OUR CAPACITY

CONTACT US!

We are ready to reply your questions with our Technical Team.
Since 1987 we have been working for quality service and high efficiency.